Tried that, and it tells me no such image still. On Sun, Nov 11, 2018 at 5:27 PM Fredrik Rinnestam <fredrik@rinnestam.se> wrote:
On Sun, Nov 11, 2018 at 05:20:31PM -0700, bobby wrote:
I did that, and it returned: "No such image. [Tab] shows a list.". When I do [tab], it returns CRUX, which puts me at where I started.
Try something like image=/boot/vmlinuz append="root=/dev/xvda1"
On Sun, Nov 11, 2018 at 5:14 PM Fredrik Rinnestam <fredrik@rinnestam.se> wrote:
On Sun, Nov 11, 2018 at 05:06:54PM -0700, bobby wrote:
It seems I am using LILO, because when I hold down shift to get into single user mode it gives me this prompt: LILO boot: How do I enter single user mode via this?
According to https://www.tldp.org/HOWTO/html_single/LILO/#ss2.3
you can probably just enter root=/dev/xvda1 (I'm just guessing here according to what your initial screenshot suggested)
/f
On Sun, Nov 11, 2018 at 5:05 PM Fredrik Rinnestam < fredrik@rinnestam.se> wrote:
On Sun, Nov 11, 2018 at 04:54:51PM -0700, bobby wrote:
Where is the bootloader conf file located at?
Depends on what bootloader you use. If its lilo you should have a /etc/lilo.conf file. You then run 'lilo' to write the changes to the bootsector.
grub uses /boot/grub/grub.cfg and looks at the config each time you boot. So no need to do anything else.
/f
> > > > VFS: unable to mount root fs is due to the kernel not having the device > > driver for the root filesystem built in to it or not having the device > > driver for the disk bus built in. > > > > I imagine that xcp-ng, whatever that is, presents different devices to > the > > virtual guest than virtualbox did. > > > > -Daryl > > From what I can tell it just looks like the root= needs to be adjusted > in the bootloader. root=xvda1 perhaps? > > Not at all familiar with xenserver so forgive my ignorance. >
--
Fredrik Rinnestam _______________________________________________ CRUX mailing list CRUX@lists.crux.nu https://lists.crux.nu/mailman/listinfo/crux