On 1 dec 2011, at 14:24, samwyse <
samwyse@gmail.com> wrote:
> I only recently discovered Crux, while looking for a small distro to use as the basis of a virtual appliance. I downloaded the ISO, created a VM, and followed the directions in the handbook to install. For some crazy reason, I decided to give JFS a try as my root file system. Unfortunately, my disk won't boot. I can boot from the ISO and mount the disk just fine, but the VM's Phoenix BIOS skips over the disk and goes straight to PXE.
>
>
> Here's my lilo.conf:
> #
> # /etc/lilo.conf: lilo(8) configuration, see lilo.conf(5)
> #
>
> lba32
> install=text
> boot=/dev/sda
> image=/boot/vmlinuz
> label=CRUX
> root=/dev/sda1
> read-only
> append="quiet"
>
> # End of file
>
>
> Here's my fstab:
> #
> # /etc/fstab: static file system information
> #
> # <file system> <dir> <type> <options> <dump> <pass>
>
> /dev/sda1 / jfs defaults 1 1
> #/dev/#SWAP# swap swap defaults 0 0
> #/dev/cdrom /cdrom iso9660 ro,user,noauto,unhide 0 0
> #/dev/dvd /dvd udf ro,user,noauto,unhide 0 0
> #/dev/floppy/0 /floppy vfat user,noauto,unhide 0 0
> devpts /dev/pts devpts defaults 0 0
> none /sys sysfs defaults 0 0
> none /proc proc defaults 0 0
> #tmp /tmp tmpfs defaults 0 0
> #shm /dev/shm tmpfs defaults 0 0
> #usb /proc/bus/usb usbfs defaults 0 0
>
> # End of file
>