Crux boot-up time error

Fredrik Rinnestam fredrik at rinnestam.se
Mon Nov 12 00:04:39 UTC 2018


On Sun, Nov 11, 2018 at 04:54:51PM -0700, bobby wrote:
> Where is the bootloader conf file located at?

Depends on what bootloader you use. If its lilo you should have a
/etc/lilo.conf file. You then run 'lilo' to write the changes to the
bootsector. 

grub uses /boot/grub/grub.cfg and looks at the config each time you
boot. So no need to do anything else. 

/f

> > On Sun, Oct 21, 2018 at 08:25:02AM -0500, Daryl F wrote:
> > > On Sat, 20 Oct 2018, bobby wrote:
> > >
> > > > I am getting this error message after transferring my vm from
> > virtualbox =>
> > > > xcp-ng.
> > > >
> > >
> > > VFS: unable to mount root fs is due to the kernel not having the device
> > > driver for the root filesystem built in to it or not having the device
> > > driver for the disk bus built in.
> > >
> > > I imagine that xcp-ng, whatever that is, presents different devices to
> > the
> > > virtual guest than virtualbox did.
> > >
> > > -Daryl
> >
> > From what I can tell it just looks like the root= needs to be adjusted
> > in the bootloader. root=xvda1 perhaps?
> >
> > Not at all familiar with xenserver so forgive my ignorance.
> >



More information about the CRUX mailing list