CRUX

Download

crux@lists.crux.nu

January 2007

33 participants
22 discussions

Fwd: Netgear FA-311
by Helge Fredriksen 03 Jan '07

03 Jan '07

Hey, got problems after doing the change in config + $ make menuconfig $ make all $ make modules_install $ cp arch/i386/boot/bzImage /vmlinuz $ cp System.map / Lilo loading CRUXEBDA is big; kernel setup stack overlaps LILO second stage........ Helge F. On 1/2/07, Clare Johnstone <claregj(a)gmail.com> wrote: > > Hi Helge > > Device Drivers ---> > Network device support ---> > Ethernet (10 or 100Mbit) ---> > < > National Semiconductor DP8381x series PCI Ethernet support > And if you press "?" key it says: > More specific information and updates are available from > <http://www.scyld.com/network/natsemi.html>. > > Hope this helps > clare > > > > On 1/2/07, Helge Fredriksen < helgeingvart(a)gmail.com> wrote: > > Could you give me some clues as to which section in the kernel setup > > I should look in? I tried to have a look, but couldn't seem to locate it > > > in a intuitive manner... > > > > Regards, > > Helge F. > > > > > > On 12/31/06, Joe Gilmour <jgilmour(a)bigpond.net.au> wrote: > > > Helge Fredriksen wrote: > > > > Hello, > > > > > > > > I've just installed Crux 2.2 on a PC with a brand new Netgear FA-311 > > > > network card. I'm trying to launch the driver adding the statement > > > > > > > > /sbin/modprobe natsemi > > > > > > > > to the /etc/rc.d/net script. However, I found that this module > > > > probably isn't installed. How do I proceed to upgrade my system? > > > > > > > > Best regards, > > > > Helge Fredriksen > > > Welcome to CRUX. > > > > > > You need to either compile a new kernel with the natsemi code built in > > > (then you wont need to modprobe it) or build the module in whiuch case > > > > you can just build and install the modules. > > > > > > Normally a system will automatically load the modules so you shouldn't > > > need to modprobe at all. > > > > > > HTH, > > > > > > Joe > > > > > > > >

3 9

Netgear FA-311
by Helge Fredriksen 02 Jan '07

02 Jan '07

Hello, I've just installed Crux 2.2 on a PC with a brand new Netgear FA-311 network card. I'm trying to launch the driver adding the statement /sbin/modprobe natsemi to the /etc/rc.d/net script. However, I found that this module probably isn't installed. How do I proceed to upgrade my system? Best regards, Helge Fredriksen

3 3